diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Multi-Way (http://www.diyaudio.com/forums/multi-way/)
-   -   Box construction question (http://www.diyaudio.com/forums/multi-way/31175-box-construction-question.html)

TonyW 29th March 2004 09:38 AM

Box construction question
 
Hi, I'm building Vifa towers (Or I will be if my router ever arrives) and I'm wondering if I should leave a way to get the back off should I ever decide to change or have to fix the crossovers. Pulling the woofer out leaves a long reach down with two braces in the way. What do you guys do?

Tony

Vikash 29th March 2004 10:12 AM

A question that plagues my mind too, but I go for the complete seal to get the max out of bracing. I can't see it being much good just pushed against a removable panel.

Personally I would keep the crossovers outside the tower if you feel you need access to it, or make a seperate removable crossover enclosure within the main sealed enclosure.

jonz 29th March 2004 12:51 PM

You can attach the whole crossover module right behind the woofers with one screw through the middle of the board..so this way you can reach it.....or if you use on of those 3 inch speaker wire connections with the gold binding posts at the bottom of the tower you can always put it right behind there...


http://www.nexxia.co.uk/Framepages/NX-ST-003.jpg

TonyW 29th March 2004 09:11 PM

Good idea on the terminal panel. I guess I'll make seperate crossover boards for the drivers, that way thy will fit out the hole if needed.

Tony


All times are GMT. The time now is 06:29 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2