Any open range 3 way designs yet with scanspeak 10f/8424g

[Jean]

Any open baffle 3 way designs yet with scanspeak 10f/8424g

Hello!

I am looking to upgrade my current speakers, they are two piece using ss9500 and pl18+ scanspeak 8565. I was hoping to find some 8640 4" mids to replace the pl18 with but can't find any for sale.

So, it looks like 8424g is a good one, maybe even to use as open back mid?

The Madisound Speaker Store

Any designs yet with this driver in a 3 way config?

 

[Bromle]

Troels Gavesen recently published this design: ScanSpeak-3W-Discovery

 

[Pallas]

NaO Note if by open you mean "open baffle."

 

[Jean]

Open baffle. Looking to re-use my sealed 8565 and make a new top section/cabinet for T/M

 

[Pallas]

Then here's a likely excellent design: http://www.musicanddesign.com/NaO_Note_II_RS.html

 

[Jean]

Very cool, reminds me of Orion speakers... unfortunately, I am not looking for an active setup.

Curious about other open baffle designs with this driver and impressions on how well it does.

 

[Juhazi]

A 4" will be in trouble in the low end, as passive open baffle. The roll-off depends on the with of your baffle, and the same width also limits the dipole upper end.

There are many reasons why modern open baffles tend to be 4-way and active with dsp!

 

[Jean]

Okay, after doing more research I am going to scrap this idea.

Back to drawing board

 

[xrk971]

Here is a 2- way
http://www.diyaudio.com/forums/full-range/273524-10f-8424-rs225-8-fast-ref-monitor.html

 

[Jean]

Thanks! I went ahead and ordered Leap crossover design from Madisound for SS9500+10F+SS8565 to give it a shot.

I am keeping the RS225 for the RS28/RS52/RS225 project