This might prove useful on this board. You can model a driver and enter/change values via the URL. So when you want to show someone a design you can just give them the built URL.
Warning. It's far from finished, and very basic at the moment. (Sealed enclosure, with single driver only at the mo). But I thought I'd share it with you anyway
(Made up)
http://www.purplecoral.com/audio/speakerdesign/?qtc=0.6&fs=38&qes=0.4&qts=0.5&vas=70&sd=0.022&xmax=6
(SS 25W/8565-01)
http://www.purplecoral.com/audio/speakerdesign/?qtc=0.707&fs=19&qes=0.36&qts=0.34&vas=229&sd=0.036&xmax=6.5
Warning. It's far from finished, and very basic at the moment. (Sealed enclosure, with single driver only at the mo). But I thought I'd share it with you anyway
(Made up)
http://www.purplecoral.com/audio/speakerdesign/?qtc=0.6&fs=38&qes=0.4&qts=0.5&vas=70&sd=0.022&xmax=6
(SS 25W/8565-01)
http://www.purplecoral.com/audio/speakerdesign/?qtc=0.707&fs=19&qes=0.36&qts=0.34&vas=229&sd=0.036&xmax=6.5
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.