EnABL Pattern for this driver? (Bud?)

enigmaticEntity. · 12:10 PM

Hi all,

I have some cheap drivers below I would like to test EnABL on. I have some of that Micro Poly Scale Railroad stuff (Forgot the name, but it's the right one).

Is there an "optimum" pattern for these or is the default 2 rings near the surround, two on outer side of dustcap, one inside OK?

(Example shown)

enigmaticEntity. · 29th September 2010, 04:32 AM

Bump?

I might try out a pattern on an even crappier set of drivers to see if I can hear the difference and get some practice on sizing - although I should probably use water and a piece of paper for that! The nibs I have are the smaller ones at the moment, so they should be perfect for these...

planet10 · 29th September 2010, 04:39 AM

I'd start with the generic rings and then after some practise you can start learning the tap test which lets you get the driver to tell you where to put the rings.

dave

29th September 2010, 04:39 AM	#3
planet10 frugal-phile(tm) diyAudio Moderator Join Date: Oct 2001 Location: Victoria, BC, NA, Sol III Blog Entries: 4	I'd start with the generic rings and then after some practise you can start learning the tap test which lets you get the driver to tell you where to put the rings. dave __________________ community sites t-linespeakers.org, frugal-horn.com ........ commercial site planet10-HiFi p10-hifi forum here at diyA

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Power transformer question (Bud?? calling Bud)	moonbird	Tubes / Valves	11	11th March 2010 05:38 PM
EnABL application for pro horn driver.	noviygera	Full Range	5	5th February 2010 09:52 PM
Lowther DX4 with Bud Purvine Enabl pattern	limono	Swap Meet	8	14th January 2009 10:12 PM
Driver pattern, directivity and other confusing issues	mefistofelez	Multi-Way	2	19th January 2006 03:56 AM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read


	Please consider donating to help us continue to serve you. Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving

29th September 2010, 04:32 AM	#2
enigmaticEntity. diyAudio Member Join Date: Oct 2009 Location: Tasmania	Bump? I might try out a pattern on an even crappier set of drivers to see if I can hear the difference and get some practice on sizing - although I should probably use water and a piece of paper for that! The nibs I have are the smaller ones at the moment, so they should be perfect for these...

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)