ProAc 2.5 driver mounting holes

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
S

Saci

Member
Joined 2002
Hi,

I am building my 2.5 clones and I have just realized a "problem" with the driver mounting holes. According to the documentation 8535 has 3.5 mm and 2010 has 5 mm holes for the screws.

On my drivers these are "almost 4" mm and 4 mm respectively. Did you experience the same before? What do you think, can I drill the 8535 holes up to 4 mm?

Regards,

Saci
 
UrSv

UrSv

Member
Joined 2002
Saci said:
Hi,

I am building my 2.5 clones and I have just realized a "problem" with the driver mounting holes. According to the documentation 8535 has 3.5 mm and 2010 has 5 mm holes for the screws.

On my drivers these are "almost 4" mm and 4 mm respectively. Did you experience the same before? What do you think, can I drill the 8535 holes up to 4 mm?

Regards,

Saci
Click to expand...

Why would you do that? Why not just use a screw that fits the hole?
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom