K4700 PCB (Speaker Protection)

[GeorgeP1111]

Hello All...

I'm new to these forums so if I posted this to the wrong forum I apologize and tell me, I'll move it.

I wanted to buy a Veleman K4700 Speaker Protection kit but after checking around I find that it is no longer in production. I could build one from the schematic and make the changes recommended elsewhere here in these forums, but I would much rather have a PCB to make the build a whole much easier (and cleaner).

I'm assuming that there is no one out there with a kit sitting on the shelf they are willing to part with so I'm asking if there is possibly someone that built a kit and happened to scan the PCB before they started installing the components? I was thinking maybe I could try etching a PCB. Just a thought.

I have a Heathkit AR-1500 I built in 1973 and am feeding a pair of JBL L200's that I bought in 1974. I had the JBL's refoamed a few years ago because I intend to keep them till the end, and now I want to add some amp protection... Just In Case

By The Way... I did check out the ESP "Loud Speaker Protection and Muting" page and also the P33 PCB. I waiting to hear back from Rod about what components are needed for his P33 circuit. I don't like the idea of ordering a board without knowing what it's going to need (cost) for the parts.

Tnx for listening.

George

[GeorgeP1111]

Me Again... I found that the K4700 is still available so I ordered one. Please disregard the above posting.

tnx
George