Hi,
I recently completed on channel of a two way Jordan + ribbon VTL speaker. I am extremely new to speaker building (OK a few years) and have only a hacked together mic + computer measurement system.
I measured the speaker but i am getting strange results (lots of bumps and dips) where i did not expect to seen any and was wondering if it is the measurement setup.
Is there anyone is the San Francisco Bay Area who has a decent measurement setup who would help me take some measurements. I would of course bring the speaker over to your workshop / lab and compensate you for your time.
I need a set of measurements that i can take as a firm base line.
Thanks
Neil
I recently completed on channel of a two way Jordan + ribbon VTL speaker. I am extremely new to speaker building (OK a few years) and have only a hacked together mic + computer measurement system.
I measured the speaker but i am getting strange results (lots of bumps and dips) where i did not expect to seen any and was wondering if it is the measurement setup.
Is there anyone is the San Francisco Bay Area who has a decent measurement setup who would help me take some measurements. I would of course bring the speaker over to your workshop / lab and compensate you for your time.
I need a set of measurements that i can take as a firm base line.
Thanks
Neil
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.