How to set volume in 3-way active crossover?

[Shahriar]

Hi

I am building a 3-way active crossover system. Here the schematic of the crossover circuit from SILICONCHIP

http://www.4shared.com/file/45483184/f0aa2137/_3__Schematic.html

As you can see, at the last section there is a Volume control to set High, Mid, Low Seperately. (VR1, VR2, VR3)

The question is How Should I set these volumes?
The Speakers Are DIY and not Finished yet!

ThanX
Shahriar

 

[richie00boy]

I would use my ears. Set the low one on full then turn down the mid and high ones to get the balance right.