spl trace

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hello,

I have a problem with SPL trace. The trace stop before the frequency I have choosen, before reaching 20.000 it says"Specifed limit trace has been reached".

Other time it goes well beyond the end of the graph.

I'm triying to trace the FT of the Fostex FF225K and the FT17H.

What can I do?
 
My traces usually go a little over the limit line. I think it has to do with the image scaling to make the image fit the screen that screws up the proportions a bit. Open your trace up in SPLView and compare. Do they match? Also, after to set you limits, just move your cursor around and see if the numbers at the bottom line up well with the graph. If they do, then I wouldn't worry too much.

I had a heck of a time tracing an impedance plot that was on a logarithmic vertical scale. I couldn't get the numbers to match if I set the low impedance to 0.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.