Does anyone have the TS Parameters for the LCY 130 RIBBON TWEETER? I am going to use X-OVER PRO to try a X-Over design.
I contacted Ying Tai Trading Co. through their website at http://www.lcy.com.hk/ with no luck. All other manufacturers have the Driver specs available on their websites but not LCY. The only infomation that they list is:
Frequency Response : 1.8KHz-60KHz
Sensitivity : 92dB / 2.83V / 1M
Nominal Impedance : 8Ù
Magnet Type: Neodymium magnet
Ribbon Effective Area : 740mm2
Ribbon Thickness : 0.006mm
Nominal Power Handling : 150W
I know that John Krutke ( Zaph) has tested this particular tweeter, so John if you are out there, can you help with this matter?
I contacted Ying Tai Trading Co. through their website at http://www.lcy.com.hk/ with no luck. All other manufacturers have the Driver specs available on their websites but not LCY. The only infomation that they list is:
Frequency Response : 1.8KHz-60KHz
Sensitivity : 92dB / 2.83V / 1M
Nominal Impedance : 8Ù
Magnet Type: Neodymium magnet
Ribbon Effective Area : 740mm2
Ribbon Thickness : 0.006mm
Nominal Power Handling : 150W
I know that John Krutke ( Zaph) has tested this particular tweeter, so John if you are out there, can you help with this matter?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.