My setup with minidsp

[curryman]

Are you able to measure the speakers?

[lduarte1973]

not yet i dont have mesurement hardware , but it might be a bit tricky since i use 2 sets of speakers - 1st set - seas ca18rnx woofer , peerless mids and epos tweeter , 2nd set - visaton gf200 , same peerless mids and fountek cd1 tweeter

the dynavox amp feeds the tweeters , the ca740a the mids and the delta290 the woofers , the subs are active

probably i´m not looking for a flat frequency response anyway and my room is very difficult room to work with since the walls have no acoustic treatment cause the wife doesn want it

i feed the cd player via optical and pc analog

[lduarte1973]

my main problem is that i get some frequencys on voices and guitars reverberating in the room , problem is minimized if i cross from woofer too mid at 600 insted of 800hz but that might make mids sound too small (like coming from a little speaker)

[lduarte1973]

a work in progress but near the final results

[lduarte1973]

just a question , i´m running my tweeters without any protection , is that a problem ?

[lduarte1973]

i always turn the tweeter amp off before turning off the minidsp so i dont get that "thump" on tweeters

[lduarte1973]

what do you guys think of this dac to upsample my mids to 24/192 ?

Finished DAC WM8741+DIR9001+CS8421 Up-Sampling DAC-with Toroid transformer | eBay

[lduarte1973]

I´m not getting this dac anymore , i bought a 640C cd player , will use it as my digital source and use the 740C as dac to upsample mids to 24/384

[lduarte1973]

ok i bought new mesurement gear :

Behringer ECM8000 Ultra Linear RTA Measurement Condenser Microphone Mic ECM 8000 | eBay

BEHRINGER PS400 Ultra-Compact Phantom Power Supply NEW | eBay

[lduarte1973]

my first mesurement with mic only , i´m still waiting for spl meter , what does this graph tell me ? from 10 khz up it´s flat and i´ll leave above 200hz i´ll deal with it later