Stabilizing Impedance - Parallel Resistor? - diyAudio
Go Back   Home > Forums > Commercial Sector > Manufacturers > Markaudio

Markaudio Designers and builders of audiophile grade drivers

Reply
 
Thread Tools Search this Thread
Old 24th April 2013, 01:14 AM   #1
diyAudio Member
 
Join Date: Feb 2011
Default Stabilizing Impedance - Parallel Resistor?

I am near finishing a pair of Pencil 7.3s and Pencil 10.2s, will very likely end up using a sub on [whichever I prefer]. I would like to use a single series cap to limit the bass and cone excursion (and the associated nasties that go with that). The issue I have is the impedance peak on both the drivers. Seems like a cap would not be very effective if the impedance rises as much as it appears on the spec sheets.

I have a Marchand crossover that I will use as a low pass filter. It does not provide an acceptable level of quality to use the high-pass section. (I have not heard any bi-amp crossover that does. It is not an option. That is not the reason or topic of this thread.)

Would it be reasonable to use a resistor in parallel with the driver to help limit (dampen down?) the peak? Would there be any adverse impact on the sound by doing this?

My amps deliver over 150 watts so that is not an issue.
  Reply With Quote
Old 24th April 2013, 10:09 AM   #2
diyAudio Member
 
Scottmoose's Avatar
 
Join Date: Mar 2005
Location: UK
A parallel shunt resistor will lower the overall impedance and would reduce the resonant peak in free air somewhat. Efficiency &c. will be impacted, but it might (might) help make a 1st order high-pass at a fairly low frequency more practical. The pensils, if damped to the default level, present a fairly unreactive load as-is, so there's a slightly better chance of it working than it might normally do. As a rule though, this is not an approach likely to work all that well with vented boxes; if a 1st order high-pass is required at a relatively low frequency, that usually mandates the driver in question being in a sealed cabinet with a proper notch on it, which is not a cheap undertaking given the size of the components needed (and the fact that these need to be of high quality).
  Reply With Quote

Reply


Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Impedance of parallel transformers ehous Analog Line Level 5 6th May 2011 08:41 PM
Coil with resistor in parallel for midwoofer? martinbls Multi-Way 2 22nd March 2011 08:37 AM
What happens if you put a resistor parallel to the potentiometer? wwenze Everything Else 5 25th June 2010 06:39 AM
resistor in series or parallel mace Multi-Way 4 21st January 2008 09:21 PM
Parallel LM3886 output resistor(s) markiemrboo Chip Amps 4 22nd July 2007 09:03 PM


New To Site? Need Help?

All times are GMT. The time now is 09:13 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2