Hello from Slovenia

Squalo · 5th November 2002, 05:56 AM

Hello to everybody on this forum !

I live in Slovenia and I'm interested in all kind of electronics. My major interests are audio electronics and computers. Until now i've made a couple of audio amps and preamps (Rod Elliot P3A, TDA7294 based amps, car audio amps with TDA1562Q, JFET preamp, Nelson Pass Bride Of Zen preamp, active crossovers, VU metters, ...) For all this stuff I've made PCB's myself (usualy my design). For designing PCB's I mainly use EAGLE for Windows, Board Editor 4.0 - Freeware and TANGO for dos. I've also made loudspeakers with Westra unit - low cost but quiet good sounding.

Beside electronics I also enjoy repairing old cars (especialy old Citroen A typs like 2CV, Dyane, Ami).

I think is enough information about me for now. If you wish ask me somthing - feel free to do it !

Cheers!

Bostjan

Stabist · 5th November 2002, 06:46 AM

Bostjan Hi!

We share 2 passions - Citroëns and DiY

Btw - par tem nazaj smo že obdelali malo slovensko sceno na tem forumu - poglej si še tisto! (for others - just explaining him that similar topic with greetings from Slovenia is allready established)

Sander · 6th October 2004, 08:11 PM

sdsd

Stabist · 13th October 2004, 11:11 AM

???

bubacka · 16th January 2005, 04:44 PM

Hello Squalo.
Since you have build few amplifiers with TDA1562Q I think you might help me.
Recently I have build this amplifier and I ran into a problem. it is supposed to give 55 watts RMS/4 Ohms, or 70W musical power on 4 ohms but it wong get as near as it is supposed to.
Compared to my rotel RB-971mk2 which is 80W per channel musical power this one sounds like half of it.
This amplifier is supposed also to be more powerful than Pioneer's
4 x 50 MOSFET, but it is not, check out the schematic for details.
The TDA1562Q has a supply voltage from 12V to 15V I powered it with 12.7V directly from car battery and it didnot give good results.
The IC has a diagnostic facility that whenever it gets near clip it temporary shuts down the output but in my case it happens when it is on 1/2 of the output power, and sometimes on lower volume.
I dont know what is the problem, PLEASE HELP.
Datasheet of TDA1562Q

bubacka · 16th January 2005, 04:44 PM

Checkout the attachment

5th November 2002, 05:56 AM	#1
Squalo diyAudio Member Join Date: Nov 2002 Location: Slovenia	Hello from Slovenia Hello to everybody on this forum ! I live in Slovenia and I'm interested in all kind of electronics. My major interests are audio electronics and computers. Until now i've made a couple of audio amps and preamps (Rod Elliot P3A, TDA7294 based amps, car audio amps with TDA1562Q, JFET preamp, Nelson Pass Bride Of Zen preamp, active crossovers, VU metters, ...) For all this stuff I've made PCB's myself (usualy my design). For designing PCB's I mainly use EAGLE for Windows, Board Editor 4.0 - Freeware and TANGO for dos. I've also made loudspeakers with Westra unit - low cost but quiet good sounding. Beside electronics I also enjoy repairing old cars (especialy old Citroen A typs like 2CV, Dyane, Ami). I think is enough information about me for now. If you wish ask me somthing - feel free to do it ! Cheers! Bostjan

16th January 2005, 04:44 PM	#5
bubacka diyAudio Member Join Date: Dec 2004 Location: Skopje	Problems with TDA1562Q car amplifier Hello Squalo. Since you have build few amplifiers with TDA1562Q I think you might help me. Recently I have build this amplifier and I ran into a problem. it is supposed to give 55 watts RMS/4 Ohms, or 70W musical power on 4 ohms but it wong get as near as it is supposed to. Compared to my rotel RB-971mk2 which is 80W per channel musical power this one sounds like half of it. This amplifier is supposed also to be more powerful than Pioneer's 4 x 50 MOSFET, but it is not, check out the schematic for details. The TDA1562Q has a supply voltage from 12V to 15V I powered it with 12.7V directly from car battery and it didnot give good results. The IC has a diagnostic facility that whenever it gets near clip it temporary shuts down the output but in my case it happens when it is on 1/2 of the output power, and sometimes on lower volume. I dont know what is the problem, PLEASE HELP. Datasheet of TDA1562Q __________________ Martin Spasovski BUg

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Hi from Slovenia	ocak	Introductions	2	6th June 2009 02:44 AM
Hello from Slovenia!	Grandma´s_SUB	Introductions	2	7th November 2004 08:06 AM
Greetings from Slovenia !!	jazzy	Introductions	31	24th November 2002 10:27 PM
Hello from Slovenia	borisov57	Introductions	0	6th February 2002 12:55 PM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read


	Please consider donating to help us continue to serve you. Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving

5th November 2002, 06:46 AM	#2
Stabist diyAudio Member Join Date: Sep 2002 Location: Slovenia	Bostjan Hi! We share 2 passions - Citroëns and DiY Btw - par tem nazaj smo že obdelali malo slovensko sceno na tem forumu - poglej si še tisto! (for others - just explaining him that similar topic with greetings from Slovenia is allready established)

6th October 2004, 08:11 PM	#3
Sander diyAudio Member Join Date: Oct 2004	sdsd

13th October 2004, 11:11 AM	#4
Stabist diyAudio Member Join Date: Sep 2002 Location: Slovenia	???

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)