Vox AC 30SS Vibrato problem

[casarete]

Hello to all,

sorry to disturb you, but I need your advice because I can not
connect properly the amplifier vibrato tab to vox ac30 been solid guitar ..

basically I can not understand how to connect the wires of the transformer on the relevant tab of the vibrato.

following the links of the picture for you to understand the problem ..

An externally hosted image should be here but it was not working when we last tested it.

An externally hosted image should be here but it was not working when we last tested it.

An externally hosted image should be here but it was not working when we last tested it.

An externally hosted image should be here but it was not working when we last tested it.

Thank you in advance for your response and the help

 

[Bone]

Sorry cannot see any pictures.

 

[JonSnell Electronic]

If you use the service manual, you will see how to wire it back up.
Yes, no pictures!

There are no transformers used for the tremolo!
https://www.elektrotanya.com/vox_ac30_ss_sch.pdf/download.html

 

[casarete]

Bone hello, hello JonSnell Electronic,
thank you for having responded to my request for help ..

below point out the photos link:


https://www.flickr.com/photos/132367757@N08/31972016600/in/dateposted-public/
https://www.flickr.com/photos/132367757@N08/32198731352/in/dateposted-public/
https://www.flickr.com/photos/132367757@N08/32228864471/in/dateposted-public/
https://www.flickr.com/photos/132367757@N08/32198698972/in/dateposted-public/


in fact, on the Amplifier scheme AC30SS there is this transformer ..
last year on the internet I could find a person
that had my same amplifier and kindly sent me
photos of the boards of his AC30SS amplifier and noticed that
in his amplifier he was not present a dedicated tremolo tab,
and the potentiometer is connected directly to the motherboard ..

I bought this amp as used and the tremolo card
was already disconnected, in short someone he had already put their hands to
try to solve a problem and probably reconnected bad
wires incorrectly transformer, because the 2 blacks transformer wires
were connected: 1 Grounded (OK) and 1 to positive
RCA connector tremolo box (?).
the 2 red wires of the transformer were connected: 1 to the resistance (I think ok)
and 1 to ground (?).

I unplugged one black wire and one red wire suspect,
my doubt is: how to connect these two wires?