diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Instruments and Amps (http://www.diyaudio.com/forums/instruments-amps/)
-   -   Finished AX84 Hi-Octane (http://www.diyaudio.com/forums/instruments-amps/227980-finished-ax84-hi-octane.html)

dipsi111 16th January 2013 08:34 PM

Finished AX84 Hi-Octane
 
3 Attachment(s)
Hello

I've just finished the AX84 Hi-octane in an open baffle combo box with 10" Jensen CH-MOD 10/35. I'm verry pleased with the sound on lead (distorted) and also on clean switch position whitch I installed. Here are some photos of finished combo.

Cheers Boštjan

AmpKiller66 16th January 2013 11:56 PM

Congrats, looks like a fine piece of work. Now how about some sound clips or a Youtube video?

cyclecamper 17th January 2013 01:58 AM

Where does the tube heat get out? It looks like it traps the rising heat like a hot air balloon until the chassis turns into an oven. Usually the back board leaves a gap at the chassis for hot air to escape. I guess they must not get that hot?

Now you need to find one of those places that laser-etch a nice faceplate. And eventually make a classy grillecloth frame.

I've got to look into the ax84 cooperative again...

Tesla88 17th January 2013 07:03 AM

I built the AX84 HiOctane too! Only the head because i've some celestion loaded cabinet to play with...
I added a send return circuit (all tube based) and a push pull design with EL84 giving 12W rms.
Clean is really warm and is easy to go into saturation zone , i've done some mod to the tone control section because distortion sound was to fizzyng !

Nice build man! What do you use for finishing/black wood?

For the heat related issue , you can just use a black metal grill instead of the svrewed wood panel on the back...


All times are GMT. The time now is 02:33 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright ©1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2