i'm planning on replacing some of the caps in this amp. i have successfully replaced caps in a gibson skylark but this one is another kind of animal!
i'm unable to read the bottom of the filter cap to know which connections are proper. the can reads 80mf/450, 30/450, 20/450 and 40/150. the schematic shows two 20mf caps. if i'm correct, i think the 40/150 is proper and i could use two 20mf/200-250v in its place.
also, the yellow sprague cap is a 30mf/450v.
where would i find the proper replacements? so far, i believe i can easily find the rest of the electrolytics but, im not sure about these two situations.
i'm enclosing a picture of the can, separate sprague cap and the schematic.http://i219.photobucket.com/albums/c...p/DSCN6729.jpg
any suggestions are appreciated.
|All times are GMT. The time now is 11:38 PM.|
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2013 DragonByte Technologies Ltd. (Resources saved on this page: MySQL 20.00%)
Copyright ©1999-2013 diyAudio