diyAudio (
-   Instruments and Amps (
-   -   BEHRINGER EP1500 frequency response (

Mambo 2nd September 2009 09:43 AM

BEHRINGER EP1500 frequency response
2 Attachment(s)
Hello to all,
I'm just doing some simulations using the EP1500 schematic that can be found on the net, and the AC analysis shows a frequency response that start dropping considerabily at 100Hz

I attached the graph of the AC analysis

I think it can be due to the double .15uF cap in series before the OP-Amp that drives the output stage, as You can see in the other attached image

Does anyone of You have a frequency response graph of the behringer in order to check it?
Or, could it be tha the values of the two .15uf caps reported in the schematic are wrong?

Thank You Very Much

Mambo 2nd September 2009 09:50 AM

Sorry for the wide distribution ...
I just found that the 2 .15uf caps are part of the low-cut filter connected to one of the switches: bypassing them as per the circuit the response is now flat and dominated by a 10uF cap

All times are GMT. The time now is 07:37 PM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 18.75%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio