my gilmore class A amp

[Remolon]

The PCB has been made for me, specifically for this project. I sent the Gerber files to MyroPCB and I received the PCB in around ten days, via UPS.

 

[Jenyok]

Output (m)W on 32 Ohm load with power +-15 Volts ?
Output (m)W on 300 Ohm load with power +-15 Volts ?
.
Total Harmonic distortion ?
Total IM distortion ?
Total noise floor ?
.
Input impedance, Ohm ?
Output impedance, Ohm ?
.
Total current (m)A, of Q9 ?
Total current (m)A, of Q11 ?
Total current (m)A, of Q13 ?
Total current (m)A, of Q15 ?
Total current (m)A, of Q10 ?
Total current (m)A, of Q12 ?
Total current (m)A, of Q14 ?
Total current (m)A, of Q16 ?
.

 

[Cestrian]

I made one too!

I have built one too. It is a fine sounding amp. Obtaining the jFETs was a challenge but after some fakes from China I found an Ebay seller who has genuine matched, for a cost.

An externally hosted image should be here but it was not working when we last tested it.

I am really pleased with the sound from this device, very open, sound-stage huge and bass very nice.

I did re-capture the cct in KiCad and had the pcbs made at JlcPCB in Hong Kong.