Still another board left or make it two if I can make an 1khz reference too
And maybe a 100khz one as well as I'm on it. So it will make three boards if it is better than make one board switchable between different frequensies.Regards
Hello all,
The EOSC10Kv2 oscillator PCB has been updated with new SMD design,
allowing much smaller size.
The circuit use now LT1229 OPAMP instead of LT1230 that are difficult to find.
Overall bom cost is greatly reduced.
The bare PCB are also much less expensive because of their smaller size,
the new price is : 17€ inside EU and 18€ outside EU.
The price include the shipping, Paypal fees and a complete design folder
send by e-mail. Some are available, if interested please send PM.
I opened a new dedicated thread for this design, you can read more about it HERE.
Regards
Frex
This new PCB look like this :
The EOSC10Kv2 oscillator PCB has been updated with new SMD design,
allowing much smaller size.
The circuit use now LT1229 OPAMP instead of LT1230 that are difficult to find.
Overall bom cost is greatly reduced.
The bare PCB are also much less expensive because of their smaller size,
the new price is : 17€ inside EU and 18€ outside EU.
The price include the shipping, Paypal fees and a complete design folder
send by e-mail. Some are available, if interested please send PM.
I opened a new dedicated thread for this design, you can read more about it HERE.
Regards
Frex
This new PCB look like this :
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.