Registered: February 2009
Location: Willich, Germany
The WM8804 and other I2S converter typical supply voltage equals 3.3V.
The I2S attenuators from ecdesigns i am using on my DAC module are designed for 5V TTL levels only.
So we need a buffer between the output of these 3.3V devices and the input of my DAC module
for a proper work, without canceling the advantages of the I2S attenuators.
If a I2S Converter has an onboard buffer like the Teralink X2, you don´t need this module.
If not, i have made a small "Ultra High Speed Buffer" Module, for the three data lines we need.
To get no interferences between the data lines, i made a discrete layout witch based on the fastest single buffer chip,
the NC7SZ125 to prevent additional added jitter.
- 2mm pcb
- Immersion Gold
- green soldermask on both side
- 35µm copper weight
- Board size 50mm x 42mm
| · Date: Tue December 28, 2010 · Views: 15385
· Filesize: 49.4kb, 1518.1kb · Dimensions: 1709 x 2064 ·
|Keywords: Ultra High Speed Buffer Module|
|Additional Categories: Digital|