diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Full Range (http://www.diyaudio.com/forums/full-range/)
-   -   Help needed about Lowther DX3! (http://www.diyaudio.com/forums/full-range/79788-help-needed-about-lowther-dx3.html)

Sclalars 18th May 2006 11:43 AM

Help needed about Lowther DX3!
 
Can anyone tell me where to find screws to fit the center cone on DX3?
I think it is a 3,5mm screw, maybe 4 mm, or something in inch?
I`ve tried to find some here in Norway, but no luck.
And it aught to be a none magnetic metal like brass.
Thanks in advance for any replies!!

Lars

Bob Brines 18th May 2006 12:28 PM

From all I know about Lowther drivers, everything is designed in English units. Without actually measuring the screw on the phase plug, my guess is that it is a 4-48 thread. Good luck in locating exactly two of these in brass, even in the USA. Living out in the sticks as I do, I'd probably wind up mail ordering a box of 100.

Bob

Sclalars 18th May 2006 01:57 PM

Thank you Bob. Ordering a 100 would not be a problem. I want to tweak and I`m going to make several different phase plugs just for fun.
So, if anyone knows where to buy, let me know!

Lars

Sclalars 20th May 2006 11:00 AM

Can anyone confirm that 4-48 tread is the right one?
Thanks in advance for any answer!!

Sclalars

Sclalars 27th May 2006 07:30 AM

Just to inform, to others who may need the information, talked to Lowther UK and the tread is M3,5.

Jon Ver Halen 28th May 2006 08:27 PM

Lowther Phase Plug Threading
 
Ya know, you can learn too much about Lowthers if you really spend time at it. Like me.

The original thread for the phase plug was an old pre-SAE type standardized by English clock makers. Can't remember it's exact number, but almost impossible to find.

It happens to be the exact same size as 3.5m x .6. Since there are 2 different 3.5 mm threads (fine and coarse) you must also use the 2nd number.

Because of my work I have a tap and die, along with brass rod that is used to make non-magnetic phase plug threaded rods. And, 'cause I am a nice guy, you can have some for the asking. Just send me your mailing address. Would normally give away up to 6", let me know if you need more.

Jon Ver Halen
Lowther-America

Sclalars 28th May 2006 09:08 PM

Thank you very much for your reply Jon!

Here`s my mail adress: lschrode@broadpark.no

Thanks in advance!

Lars Schroeder


All times are GMT. The time now is 02:14 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2