where is radioshack drivers on site?

[AudioGeek]

trying to search for the radioshack drivers on the RS website. Cannot find any... do they still make some?

any good fullrange drivers (60Hz - 10khz to 15khz) out there for relatively inexpensive??

i need 8 of them and don't want to spend a lot... just trying an experiment and don't want to throw away a lot of money.

Thanks!

[hongrn]

Check this driver out.

Hong

Aurasound NS3-194-8E 3" full range

[planet10]

That Aura is more of a mid tweeter....

This one is the best 3" i've seen

http://www.madisound.com/cgi-bin/ind....27520&pid=100

Radio Shack has pretty much abandoned the diy speaker builder... finding the choice RS drivers like the 1197 or 1354 means finding someone like me or Woody with a stash & talking them out of some of them.

dave

[hongrn]

I think Richard wanted something inexpensive...

[RogerWilco]

Originally posted by hongrn
Check this driver out.

Hong

Aurasound NS3-194-8E 3" full range

Not bad----Frequency 80 to 15kHz

Wish it went higher than 15khz

[planet10]

Originally posted by hongrn
think Richard wanted something inexpensive...

$20 is expensive?

The Aura you posted might get down to 200 Hz... the other will get to almost 100.

A pr of 1197s will likely set you back $25 USD, 1354s are fetching a lot more (as much as $100/pr)...

dave

[planet10]

Originally posted by RogerWilco
Not bad----Frequency 80Hz

Not with an Fs of 125 Hz...

dave

[GM]

1354s are fetching a lot more (as much as $100/pr)...

Where?

GM

[planet10]

Originally posted by GM
Where?

Alabama... Steven Brown found 4 NOS 1354s and a friend who had heard his unfolded tapered TLs offered (& paid him) him $200 for them.

I'd happily sell the ones i have if someone offered me that much. Probably an outlier but still an indicator of the value some place on them.

dave

[AudioGeek]

i am looking to do this as an experiment:

4 drivers one on each side of enclosure.. all wired same phase so no need for a BSC.

these drivers are run full with no filtering. probably looking for 50-60Hz ported enclosure.

now i do not know what top end frequency these will run to.... but i will place a tweeter facing up on the top of the enclosure.

so the question remains... what should the x-over frequency be on the tweeter?

this post could be on the regular loudspeaker forum but the 4 drivers on side of enclosure are more full range than anything.

maybe i only need them to go to 10kHz.

so a 5 1/4 driver run flat to 10kHz... like vifa MG10SD09-08 but this is a little over my budget.... at least for an experiment.

All i want is a cheap 5 1/4 driver that has a flat frequency response on axis and off...