|25th June 2005, 02:22 AM||#11|
Join Date: Jun 2003
Location: Chamblee, Ga.
Yes, this is what I had in mind, so using published specs (all dims are inside):
L = 56"
CSA (width x depth) = 75"^2
driver down = 19.42"
vent = 3" dia. x 7" long
suggested stuffing = ~24 oz of polyfil evenly distributed from top down ~45"
This sims a near IB response, so unless up against a wall it will probably need some BSC, and even then the bass will roll off below ~80 Hz.
Note though that the specs don't match up all that well with calc'd ones, so you may want to try a 3" long vent also before adding any BSC.
Loud is Beautiful if it's Clean! As always though, the usual disclaimers apply to this post's contents.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|How do single driver (read loaded) horn speakers actually sound?||hugz||Full Range||50||11th July 2015 08:57 PM|
|Efficient Single Driver Bookshelf Speakers||pjanda1||Swap Meet||2||7th July 2009 10:43 PM|
|Single Ended, Single driver: In-room distortion measurements||Gerrit Boers||Full Range||4||27th November 2007 08:12 AM|
|Why do you prefer single driver speakers?||Taterworks||Full Range||42||4th July 2007 12:21 AM|
|Digital amps and single driver speakers, opinions?||Taperwood||Full Range||30||20th March 2006 01:06 AM|
|New To Site?||Need Help?|