diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Full Range (http://www.diyaudio.com/forums/full-range/)
-   -   Fe107e offset driver TL (http://www.diyaudio.com/forums/full-range/33558-fe107e-offset-driver-tl.html)

Dave Jones 5th May 2004 07:31 PM

Fe107e offset driver TL
 
Hey guys, would you be kind enough to criticize a proposed design? Check out the thread below.
The design is in message #8. By the way, I used 4.5 for BL, and 16*pi cm^2 for the effective cone area.

http://www.diyaudio.com/forums/showt...threadid=33498

Bob Brines 6th May 2004 12:21 AM

Looking at the plot, assuming that the input parameters are correct, something is very wrong here. My gut feeling without running sims is that the pipe is way to big for the driver. It is also way over stuffed, as can be seen by the gradual fall-off at the low end. But, it needs the stuffing to smooth out the higher harmonics, and it's not doing that well.

I don't like small drivers in pipes. There is too much temptation to make the driver go too low. The FE107E is a mid-tweet, not a mid-bass. It deserves to be used as such in a horn or OB, or even a sealed box, but not in a pipe.

Just my opinion. Sorry.

Dave Jones 6th May 2004 02:20 AM

Yep. It's junk. Everyone please disregard. :-(


All times are GMT. The time now is 07:26 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2