Whipped up 6 pairs of these:
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
Not without damaging one of the drivers:
And the solution to that problem.
An externally hosted image should be here but it was not working when we last tested it.
And the solution to that problem.
An externally hosted image should be here but it was not working when we last tested it.
Each one is made out of 1/2" bamboo plywood. Internal volume is 13.8 liters. Tuned to ~47Hz with a 1" diameter by 1.1" long port.
F3 is simulated to be 40Hz and I believe it. Haven't measured it yet though.
The baffle is relatively wide to reduce the effects of baffle step. There is no BSC or any filters in this speaker.
Just 10" of supra ~16 gauge wire between them at the terminals on the back.
Internal dimensions are all golden ratio.
F3 is simulated to be 40Hz and I believe it. Haven't measured it yet though.
The baffle is relatively wide to reduce the effects of baffle step. There is no BSC or any filters in this speaker.
Just 10" of supra ~16 gauge wire between them at the terminals on the back.
Internal dimensions are all golden ratio.
Thank you everyone. I'll be building another batch in the summer, but this time use this material instead:
http://www.bamboohardwoods.com/downloads/specs/TigerPanel_SpecSheet.pdf
http://www.bamboohardwoods.com/downloads/specs/TigerPanel_SpecSheet.pdf
gorgeous stuff too - but note that "grain" / pattern matching/wrapping on these types takes a lot more careful layout, and can have a much lower yield
Yeah, I only matched the panels on the speaker by darkness. I can barely fit 3 pairs on one 4x8 sheet
Here are the prototypes, built entirely from scrap:
An externally hosted image should be here but it was not working when we last tested it.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.