diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Full Range (http://www.diyaudio.com/forums/full-range/)
-   -   Ohm Walsh 2 need advice (http://www.diyaudio.com/forums/full-range/195930-ohm-walsh-2-need-advice.html)

Sk8Ter 4th September 2011 04:54 PM

Ohm Walsh 2 need advice
 
Looking for some "ideas" on how to make the ohm f have more extended more robust bottom end

Inside the cabinet is the original thick cotton material that extends around the cabinet .. in the middle uses broken up pieces of this cotton material that is only on the very top(closest to the driver) and nothing underneath...

Ideas Please

Lawrence

picowallspeaker 4th September 2011 05:51 PM

"new input terminals with gold-plated binding posts and 12 gauge OFC interal wire. This allows for deeper bass and wider dispersion of the high treble"
I read it at the Ohm site :p
Please note that I'm not a cable or Super Solid Brass fan ,but optimum conductivity and bottle -neck avoidance should be performed by every DIYer.
Cotton can be replaced by some lighter ( air permeable ) material ,such as Dacron , not allowed to move inside the cabinet , just attach it by glueing it to the internals . maybe they put it in the middle to overcome the probably stationary wave due to the high height /base ratio .:confused: :rolleyes:


All times are GMT. The time now is 04:22 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2