diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Full Range (http://www.diyaudio.com/forums/full-range/)
-   -   Attenuation circuit findings Fe208e sigma (http://www.diyaudio.com/forums/full-range/169007-attenuation-circuit-findings-fe208e-sigma.html)

adamt 22nd June 2010 03:20 AM

Attenuation circuit findings Fe208e sigma
 
So after extensive listening, and fiddling, I have finally settled on my circuit to control the midrange peak of this driver. I like my sound a bit softer in the highs, so I have opted for a 0.33mH, 2.7uF, 5.6 ohm solution, before crossing to a horn tweeter with just a 0.40uF cap.

The thing is, I wire these three items in parallel, and then put it in series to the driver. The sound is fine. Then I wire it in series, and put it across the speaker terminals and it sounds the same.

Is it suppose to sound different? Is one preferred over the other?

thanks!


All times are GMT. The time now is 03:32 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2