Nagaoka Swan D-101

[babgrip]

Does anybody have a decent set of plans for the SWAN D101.All that i have found are a hand drawn cut sheet in cm and no assembly plans. I plan on using the fostex 108es thanks

[Aengus]

Have you looked here?

Regards.

Aengus

[serenechaos]

also:

http://209.85.171.104/translate_c?hl=en&langpair=ja|en&u= (add for translation, or use bablefish)
http://www.geocities.jp/ybb_tatsuyan..._7TqgHpQJlO5Nw
animation of how it goes together even.
simple, all straight cuts.
use the drop-down menu on the left for dwawings, pictures, etc.

http://homepage3.nifty.com/spida/eng-page9.htm
main page; translation, hard to follow, but links all over the place; e.g. http://homepage3.nifty.com/spida/eng-page7.htm
good picts, views, info, just have to work for it...
r

[babgrip]

Thank you for your reply's . I had been to this website but did not realize that the new drawings opened to a different file . Now i have one more question before i can begin . I have not been able to find the dimension for the thickness of material Mr Nagaoka used in his build .I have attached photo of my first DIY speaker the Harvey BVR . Many thanks to Scott Lindgren for his design.

[serenechaos]

the links on: http://homepage3.nifty.com/spida/eng-page7.htm &
http://homepage3.nifty.com/spida/eng-page9-1-3.htm
say: 15mm thick 910×1820mm plywood is half [two sheets and]-used.
from home page:
http://homepage3.nifty.com/spida/framepage%20eng-9.htm

But I used 5 x 5 x 3/4" baltic birch, & had to adjust so internal dimensions stayed the same...
Came out very stiff, doesn't vibrate at all, may have been overkill?

[babgrip]

Did you just add 3mm to all the dimensions and build entire cabinet out of 3/4 ply
Do you have any build photos

[serenechaos]

not exactally...
mine are the super swans; dimensions are slightly different anyway because it's for 108es-II drivers.
but yes, I modified it so the inside dimensions remained the same--area/length/volume.
It took a little while to figure out...
No, didn't take pictures of anything; didn't even have a camera...

lotsa build photos in those links tho, even animation of how it goes together.

[babgrip]

Guess i will have to find some 15mm ply in my area, and buy a metric ruler .Calculations are not my stong point. Give me a plan and i can build it .This should be a challange .the only link that opens is the SPI sound plaza and i cant find any videos.thanks again and i will stop pestering you .
Ben

[planet10]

Originally posted by babgrip
15mm ply

=5/8"

dave

[babgrip]

Here is a photo of a mock-up i made from 1/4 " luan and hot glue tonight do the baffles looK like they are installed correctly thanks
BEN,