S.P.Q.R. Model III

[Harderror]

Sorry to start a new thread but I wanted an area to differentiate the final drawings for the Model III and to discuss the build process and results as well as post pictures and such.

The final drawings contain cut sheets for baltic birch (5' x 5' sheets). They can be transfered to regular 4' x 8' sheets of birch or maple plywood by the builder.

As always, this design and all drawings contained herein are copyright, Thomas Petzwinkler, 2008. All use is private DIY. Any and all commercial use and distribution is strictly prohibited by law. This design, file and the contents therein represent the intellectual property of said copyright holder: Thomas Petzwinkler, and any use other than private DIY is also strictly prohibited by law. By downloading, printing, or viewing the aforementioned file, you agree to the terms set forth in this statement.

Ok, enough babbling. Here they are!
http://www.box.net/shared/2btbvojcwo



Tom

[audioray]

hello
nice desing. would the fostex fe206 ESR work in this enclosure. would it need some changes
thank you

[Harderror]

The fe206esr should work perfectly. A BL of over 10 and Qt of .19 is right on the money for the best performance. If I have time, I will sim it but I know from the numbers that it will work fine. Good Luck!

Tom

[Harderror]

Here you go, I had a minute to sim it. The results look good.

Tom

[audioray]

tom
its in my front burner. i have the fe206esr mountedi n fostex fe208 boxes now.
will mount fountek 5" ribbons near top.
thank you