I once eyeball simmed Bruce with AJ - but not sure of Bruce chamber, throat, path and flare - any quick guestimates?
is qts below too high for Bruce? - don't like much peaking near cutoff, stright pipe MLTW wouild work, fat BIB would probably work
my 1st WT2 measurements (later set pretty much the same)
Unit #1
Revc = 5.4657 ohms
Fms = 58.1931 Hz
Zmax = 52.8627 ohms
Qes = 0.5830
Qms = 5.0553
Qts = 0.5227
Le = 0.2559 mH (at 1 kHz)
Diam = 161.9504 mm ( 6.3760 in )
Sd =20599.3690 mm^2( 31.9291 in^2)
Vas = 33.9940 L ( 1.2005 ft^3)
BL = 6.7431 N/A
Mms = 13.2638 g
Cms = 563.9369 uM/N
Kms = 1773.2482 N/M
Rms = 0.9593 R mechanical
Efficiency = 1.0798 %
Sensitivity= 92.3513 dB @1W/1m
Sensitivity= 94.0057 dB @2.83Vrms/1m
is qts below too high for Bruce? - don't like much peaking near cutoff, stright pipe MLTW wouild work, fat BIB would probably work
my 1st WT2 measurements (later set pretty much the same)
Unit #1
Revc = 5.4657 ohms
Fms = 58.1931 Hz
Zmax = 52.8627 ohms
Qes = 0.5830
Qms = 5.0553
Qts = 0.5227
Le = 0.2559 mH (at 1 kHz)
Diam = 161.9504 mm ( 6.3760 in )
Sd =20599.3690 mm^2( 31.9291 in^2)
Vas = 33.9940 L ( 1.2005 ft^3)
BL = 6.7431 N/A
Mms = 13.2638 g
Cms = 563.9369 uM/N
Kms = 1773.2482 N/M
Rms = 0.9593 R mechanical
Efficiency = 1.0798 %
Sensitivity= 92.3513 dB @1W/1m
Sensitivity= 94.0057 dB @2.83Vrms/1m