EC8010 said:
Methylated spirits (that purple stuff) is much better than oil. I haven't looked back since finding that tip in Deketh.
Thanks EC!
Thanks Guys!!!
A square punch it'll be. Instead of Dremel, I use the Other tool - Proxxon. They also have some great accessories. The motor is permanently on my workbench, mounted in Proxxon's suction vise - staying firmly in place for months on end. This brand's best cutting discs are diamond-coated cutting and grinding wheels.
The only criticism I have is that their mandrels are too thin and usually snaps the screw which holds whatever disc you have on it.
A peculiarity with the Proxxon motor tool I experienced was doing a nutsplitting job on a lawnmower, done outside to see better. I fitted a diamond cutting disc in the tool and used an unwound cable drum mains lead of 30m long. After about 2mins worth of cutting, the tool got very hot and I could smell overheating electronics.
As the job was done, I decided to dismantle the tool to check for damage. There was no sign of overheated electronics and everything was OK.
Since the tool's speed control is by electronics up to 20k rpm, the extension cable I used must have had some effect, causing overheating.
So, if you use one of these, don't use it powered by a long extension lead.
bulgin
A square punch it'll be. Instead of Dremel, I use the Other tool - Proxxon. They also have some great accessories. The motor is permanently on my workbench, mounted in Proxxon's suction vise - staying firmly in place for months on end. This brand's best cutting discs are diamond-coated cutting and grinding wheels.
The only criticism I have is that their mandrels are too thin and usually snaps the screw which holds whatever disc you have on it.
A peculiarity with the Proxxon motor tool I experienced was doing a nutsplitting job on a lawnmower, done outside to see better. I fitted a diamond cutting disc in the tool and used an unwound cable drum mains lead of 30m long. After about 2mins worth of cutting, the tool got very hot and I could smell overheating electronics.
As the job was done, I decided to dismantle the tool to check for damage. There was no sign of overheated electronics and everything was OK.
Since the tool's speed control is by electronics up to 20k rpm, the extension cable I used must have had some effect, causing overheating.
So, if you use one of these, don't use it powered by a long extension lead.
bulgin
I use one of these...
When all the little sheetmetal places were either going
CNC or being knocked down and turned into coffee shops
flypresses could be had for scrap value. They do whatever
shaped hole you care to buy punches for. A 20mm square
punch does an IEC in 2 swats.
M
An externally hosted image should be here but it was not working when we last tested it.
When all the little sheetmetal places were either going
CNC or being knocked down and turned into coffee shops
flypresses could be had for scrap value. They do whatever
shaped hole you care to buy punches for. A 20mm square
punch does an IEC in 2 swats.
M
A quick google search found this. Not novel, but a good collection of methods: http://www.makezine.com/extras/15.html
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Everything Else
- I am an IEC Socket Freak