TrueRTA Cal Problem

[richie00boy]

I'm using v2.0.3 because I only have a 350MHz processor. Soundcard is AWE64 Gold.

When trying to do the input calibration, if I enter the actual measured voltage at the input it stops the analyser registering anything at all. The default setting is only a little bit out in terms of actual to what is displayed on screen, but performing the cal just makes it useless.

I'm at a loss what could be causing this - any ideas?

[richie00boy]

Now sorted. The problem was that each time you want to re-cal you need to make sure you have reset back to the default first.