Hi,
In addition to my post in the Analogue Line Level section, I thought that some readers might like to see another project I'm working on...
This is a general coverage receiver from Elektor (Jan/Feb 1999 issues). It's been hard to get some of the specialist parts in blue but I strive for perfection. Here are some photos:
Dave.
In addition to my post in the Analogue Line Level section, I thought that some readers might like to see another project I'm working on...
This is a general coverage receiver from Elektor (Jan/Feb 1999 issues). It's been hard to get some of the specialist parts in blue but I strive for perfection. Here are some photos:
Dave.
Attachments
-
001 Blank PCB.JPG617.9 KB · Views: 184
-
002 Resistors and a few Caps.JPG661.4 KB · Views: 183
-
003 A nice little bunch!.JPG533.5 KB · Views: 171
-
005 A view across the Resistors.JPG729.2 KB · Views: 169
-
006 Resistors and Capacitors.JPG660.2 KB · Views: 172
-
014 We're different - we're green! Ha ha!.JPG648.8 KB · Views: 66
-
019 Coils, crystals and filters.JPG623.6 KB · Views: 70
-
023 RF Transistors fitted.JPG589.9 KB · Views: 56
-
036 Blue coil fitted!.JPG748.7 KB · Views: 72
-
P1010385.JPG564.8 KB · Views: 82
More photos...
Here's the control PCB...
All the blue enamelled wire is silver over copper. I know that the meter is upside-down, but I don't have the correct one yet - this one is just a space model
The original code for the PIC micro was never made public and there are no pre-programmed PICs left, so I am writing the code from scratch. I have updated the PIC micro to a newer spec and the display to 2 lines instead of the 1 line the original had.
When I get it working, I'll let you all know.
Dave.
Here's the control PCB...
All the blue enamelled wire is silver over copper. I know that the meter is upside-down, but I don't have the correct one yet - this one is just a space model
The original code for the PIC micro was never made public and there are no pre-programmed PICs left, so I am writing the code from scratch. I have updated the PIC micro to a newer spec and the display to 2 lines instead of the 1 line the original had.
When I get it working, I'll let you all know.
Dave.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.