Calculation of HPF due to output capacitor, with source connected to load?

wwenze · 27th February 2010, 02:51 PM

With the load connected to the source it becomes like this:

How to calculate the cut-off frequency in this case? I'm guessing that this would result in a higher cut-off than with only 1 cap and 1 resistor.

wwenze · 28th February 2010, 03:12 AM

Hmm no replies?

Well I did some spices and what I saw - that value of C2 didn't have any effect on the filter. Though thinking about it makes perfect sense as current into the load is negligible vs current through R1 and R2.

Hmm... so no point for huge input capacitors?

27th February 2010, 02:51 PM	#1
wwenze diyAudio Member Join Date: Mar 2008	Calculation of HPF due to output capacitor, with source connected to load? With the load connected to the source it becomes like this: How to calculate the cut-off frequency in this case? I'm guessing that this would result in a higher cut-off than with only 1 cap and 1 resistor.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Choke load calculation...	HVfanatic	Tubes / Valves	9	30th January 2009 02:47 PM
GZ34 anode load resistor calculation - help?	coolmaster	Tubes / Valves	16	3rd February 2007 04:42 AM
output impedance of source follower and load in mH?	AudioGeek	Solid State	2	18th November 2005 11:02 PM
The rule to calculate the load impedance of two or more valvces connected in parallel	Antonio Tucci	Tubes / Valves	16	7th February 2004 03:49 PM
can output transistors blow when no load connected??	hugobross	Solid State	15	4th September 2003 02:11 PM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read


	Please consider donating to help us continue to serve you. Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving

28th February 2010, 03:12 AM	#2
wwenze diyAudio Member Join Date: Mar 2008	Hmm no replies? Well I did some spices and what I saw - that value of C2 didn't have any effect on the filter. Though thinking about it makes perfect sense as current into the load is negligible vs current through R1 and R2. Hmm... so no point for huge input capacitors?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)