Thanks for the reply.I was just thinking that since that little very unpractical outlet has been around for god knows how long, Maybe somebody out there could have invented some kind of commercial design/ solution for the connection.
I will probably dedicate an instrument to hfe measurement, and solder the wires directly in the instrument and make a little hole in the side of the cabinet
the hFE measurement built into DMMs is not worth much.
Most of them feed a constant fixed base current and measure the collector current.
You have no control over the collector current, nor the power dissipated, nor the temperature. Only good for a rough grouping.
Make up a little jig and do your own hFE measurement.
Most of them feed a constant fixed base current and measure the collector current.
You have no control over the collector current, nor the power dissipated, nor the temperature. Only good for a rough grouping.
Make up a little jig and do your own hFE measurement.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.