Any DIPTRACE users here... using later versions.

[Mooly]

Can't seem to figure this out... and this didn't happen in the "old" versions.
Any part I pick from the libraries such as dual opamps or a CMOS gate package for example only places "one" part of the device on the circuit.
For example a TL072 shows as pins 1,2, and 3 with supply on 4 and 8. The other half of the package is missing.... same for the CMOS, just the first gate appears with pins 1,2, and 3 and the supply. Clicking the part again just seems to paste the same pin numbers although the reference on the circuit changes U1.1 U1.2 etc.

What am I missing ? Can't even find a way to renumber the pins etc.
The old versions placed the parts correctly with say four separate gates all correctly numbered pin wise.

Thanks if anyone can help

[Mooly]

Hmmm... after struggling for ages with this have just found a "check box" which says "place all parts"

And it works... Yay

What a Dipstick lol

I'll leave the thread up... might help someone else.