I didn't know where else to post this question because it's not specific to any other sub-forum so..... here goes
I have an Adcom gcd 575 I use as an input mainly for a modified T-amp, I run it out of the fixed RCA's, never any problem . The other day I ran a line into my Yamaha receiver from the digital coax output and it sounds great through that amp/receiver and into my klipsch speakers, but........ now I get no signal at the analog jacks and I am puzzled as to what may have happened. There is no setting that switches the outputs but it seems to only be sending signal through the digital out. I also tried the variable analog and it's dead too.
Any Ideas, I'm puzzled.
Thanks
I have an Adcom gcd 575 I use as an input mainly for a modified T-amp, I run it out of the fixed RCA's, never any problem . The other day I ran a line into my Yamaha receiver from the digital coax output and it sounds great through that amp/receiver and into my klipsch speakers, but........ now I get no signal at the analog jacks and I am puzzled as to what may have happened. There is no setting that switches the outputs but it seems to only be sending signal through the digital out. I also tried the variable analog and it's dead too.
Any Ideas, I'm puzzled.
Thanks
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.