Go Back   Home > Forums > >
Home Forums Rules Articles diyAudio Store Blogs Gallery Wiki Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

Equipment & Tools From test equipment to hand tools

About to give up on Wallin Jig & Speaker Workshop
About to give up on Wallin Jig & Speaker Workshop
Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Thread Tools Search this Thread
Old 31st December 2012, 01:16 AM   #11
SpeakerBuilderB9 is offline SpeakerBuilderB9  United States
diyAudio Member
SpeakerBuilderB9's Avatar
Join Date: Mar 2010
Location: Kentucky
Default DON'T connect J4 to mic input on soundcard...

I realize this is an old thread, but for those who haven't figured it out by now, DON'T connect the J4 input to the sound card mic input. It sounds like the original poster did that. J4 is for an external microphone. It is not meant to connect to the sound card's mic input. Usually you need a measurement mic run into a mixer or phantom power device. Then you run a line-out from that device to the J4 on the jig.

Just thought I'd post in case someone comes across this old thread and is confused about the mic jack vs. J4 on the jig.

And as others mentioned, get those record levels set properly. Set your receiver volume to 1 or 2, and the Windows record mixer line-in all the way up. As mentioned in setup routines, record a sine wave and monitor the left and right "in.l" and "in.r" graphs. Change the Windows mixer sound level until sine waves don't clip. As a side note, sine waves should measure around +16k/-16k. MLS signals will be about +/-22k at this level. Click "view-vu meter" on the menu to monitor this.

Good luck to all.
  Reply With Quote


About to give up on Wallin Jig & Speaker WorkshopHide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Re-Jigging the jig: Speaker testing device for Arta, Speaker Workshop & HOLMImpulse MJL21193 Multi-Way 264 8th October 2012 01:10 AM
Wallin Jig v2 for Speaker Workshop 454Casull Multi-Way 11 20th March 2009 03:56 AM
FS: DIY Wallin Jig II for Speaker Workshop happycat Swap Meet 8 27th May 2007 07:46 AM
Speaker workshop Wallin jig setup for sale kingdaddy Swap Meet 0 7th December 2005 06:05 PM
Wallin Jig 1 for Speaker Workshop: Wiring Problem?! Rarkov Multi-Way 1 12th September 2002 09:18 PM

New To Site? Need Help?

All times are GMT. The time now is 12:46 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 15.00%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio