Universal all Film Capacitor Power Supply meets TubelabSE

[Nikon1975]

Dear DIY Hi-Supply,

I was thinking of integrating the Universal all Film Capacitor Power Supply in my Tubelab SE build, using tube rectifier. I think it should be very easy. I plan to have B+ around 380-390 V and run two tubes at about 75 mA.

What do you think of this idea ? Did anyone reported any previous experience ?

Thanks,

Davide

 

[Nikon1975]

Dear DIY HI-Supply,

I am trying to hook up the HV regulator. Now on the manual the AC side has 7 blocks and the DC side has 9 blocks. On the module I received, both side have 9 blocks !!!

Could you send me the diagram of how to connect it ?

Thanks,

Davide

 

[ThorstenL]

Dear Davide,

I am trying to hook up the HV regulator. Now on the manual the AC side has 7 blocks and the DC side has 9 blocks. On the module I received, both side have 9 blocks !!!

Could you send me the diagram of how to connect it ?

I think you best e-mail diyhifisupply directly for the manual, the technical address is:

technical (at) diyhifisupply dot com

Ciao T

 

[Nikon1975]

Thanks,

I'll do.

Davide