DEQ2496 latency

[brucemck2]

Integrating a DEQ2496 as a subwoofer EQ and want to properly integrate it into my system (it's in the chain after the receiver) ... two questions ...

(1) what's the latency / delay of the unit?

(2) what would that correspond to in terms of "feet" ... so that I can adjust the receiver's setting for relative distances of the speakers to account for the extra time delay in the Behringer?

Thanks

 

[Pulse-R]

The delay is in the order of about 1ms or so (depending on what you're doing internally), that's bout 34.5cm or 1' 1.5"

problem I have is the EQ only goes down to 20Hz, my sub plays below this, but needs a little EQ around 16-18Hz. Unit is good for ADC + EQ

 

[seoman]

problem I have is the EQ only goes down to 20Hz, my sub plays below this, but needs a little EQ around 16-18Hz. Unit is good for ADC + EQ

around 16-18Hz
How can you know? RTA stops @ 20Hz.

Why not shift the sub arround the room to get the <20Hz correct.
And then do the > 20Hz with the DEQ.

Still i wonder, how can you tell if it's correct.

Regards
Simon

 

[Pulse-R]

Hi Seoman

I use SpectraRTA software on a PC to measure RTA down to 10Hz.

and this is in the car, not the lounge, so moving the sub around is a bit awkward

seasons greeting too

Simon