diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Digital Source (http://www.diyaudio.com/forums/digital-source/)
-   -   uneven output on my 206 (http://www.diyaudio.com/forums/digital-source/69133-uneven-output-my-206-a.html)

carlos671 4th December 2005 07:30 PM

uneven output on my 206
 
HI everyone, not talking about my puegot here, but my meridian. the output from the right speaker is alot weaker when using my cd player. i measured the outputs with my mulimeter and the voltages are lower on the right channel and other source components play evenly so know its not the amp. any suggestions?

Cheers

Extreme_Boky 6th December 2005 09:31 AM

Hi,

You are going to need a CRO and circuit diagram. Follow the signal backwards until you get equal levels on both channels. The fault is probably in analog section or muting circuitry. Your CD player may have a discrete analog buffer section. This is good place to start.

Visually check the PCB for any signs of overheating. These are the most likely problem places in any unit.

Check if the power supply lines' levels are the same for both channels. Even better - measure the voltage drop across the resistors placed in series with the power supply lines. Voltage drops should be the same for both channels.

Avoid guessing - you could end up with damaged PCB.

If you are uncertain what to do - give it to a good technician (or one of us on forums close to where you live)

Good luck

Extreme_Boky

Phasenoise 6th December 2005 03:10 PM

The 206 is a nice player, meridian gear normaly is pretty reliable. You could give meridian a call or send it back to them for a service.


All times are GMT. The time now is 12:11 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2