Dr.Gone said:
It is a lot of money BUT if you already have a KI and like it but you have say £1500 to spend on a new player and you have no clue about modding then I think its good.
For us its a rip off.
I would think that KI TZG is better than a £1500 new player.
You could buy a KI off ebay for £150 and send it to them if your joe blogs off the street.
Also its good to see we are on the right lines with these mods too.
Brent
just found this
may help
http://www.diyaudio.com/forums/showthread.php?s=&threadid=28657&perpage=10&pagenumber=1
allan
may help
http://www.diyaudio.com/forums/showthread.php?s=&threadid=28657&perpage=10&pagenumber=1
allan
6h5c said:
Not yet.....lol
been to busy at work!
also not sure what value to use on r1 yet.
Ray if you have some good advice its welcome.
I specialise in lots of areas of electronics but im not major in dc ripple and its filtering.
What I have come up with is my own idea but am unsure of exact values without spending ages with scope.
awpagan said:
cheers
post 38 by ALW
undecided on super reg's
which way to go and where to acqire components
simple 317
http://www.diyaudio.com/forums/showthread.php?s=&threadid=985&perpage=10&pagenumber=4
allan
ps everyone has there views on different reg's
this is a cheap and easy solution to remove 78' series
until you find something better
but not bought
pps I think andy has already referred to the shunt reg on this thread?
undecided on super reg's
which way to go and where to acqire components
simple 317
http://www.diyaudio.com/forums/showthread.php?s=&threadid=985&perpage=10&pagenumber=4
allan
ps everyone has there views on different reg's
this is a cheap and easy solution to remove 78' series
until you find something better
but not bought
pps I think andy has already referred to the shunt reg on this thread?
Clocks and PSUs
Hi,
On the subject of clocks :-
http://www.net-audio.co.uk/microclock.html
On psu's :-
http://www.wenzel.com/documents/finesse.html
Andy
Hi,
On the subject of clocks :-
http://www.net-audio.co.uk/microclock.html
On psu's :-
http://www.wenzel.com/documents/finesse.html
Andy
poynton said:
elso's post 17
if think, in one the post's to Lars thread.
http://www.diyaudio.com/forums/showthread.php?s=&threadid=28657&perpage=10&pagenumber=2
Hi All,
Interestingly Lars (Lcaudio) and Andy (ALW) are using a opamp and a series pass transistor:
http://www.diyaudio.com/forums/showthread.php?postid=285110#post285110
http://www.diyaudio.com/forums/showthread.php?s=&threadid=985&perpage=10&pagenumber=1
allan
edit url's should work
awpagan said:
Allan,
I found this website very useful!
http://tangentsoft.net/elec/opamp-linreg.html
I think AD825 is used most often as the op amp.
It's probably used for a number of reasons, and one being the fact that if you are also building op amp modules you can bulk buy AD825!