diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Digital Source (http://www.diyaudio.com/forums/digital-source/)
-   -   Marantz CD-60 only POP :-) (http://www.diyaudio.com/forums/digital-source/41988-marantz-cd-60-only-pop.html)

seppstefano 4th October 2004 08:56 AM

Marantz CD-60 only POP :-)
 
Hi all,
a dear friend of mine has a Marantz CD-60 with reading problems. It keeps on skipping, ticking and popping while playing. The lens seems clear enough (i'll clean it better), but I fear the problem is located in another place... :confused:

Perhaps the laser is burnt out? The power supply???

Please, share any suggestion and (if possible) Cd-60 technical schema, too :-)

TIA for any help,

Stefano

jean-paul 5th October 2004 10:31 PM

Replacing the laser seems to be the solution.

Extreme_Boky 8th October 2004 01:42 PM

Hi Seppstefano,

Check your PCB and look for a point labelled RF. Monitor the RF signal on oscilloscope and look for an eye-pattern. It should be 1.5(+ or - 0.3) Vp-p. If it is lower than 1.2V you'll have the problem where the pick-up reads some disks, and does not read ones with low reflectivity. You can increase the laser output by adjusting the little trim-pot located on the pickup itself. Do not go over 1.7 - 1.8 volts.

Regards,
Extreme_Boky


All times are GMT. The time now is 04:58 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2