diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Digital Source (http://www.diyaudio.com/forums/digital-source/)
-   -   Chassis and ground (http://www.diyaudio.com/forums/digital-source/26590-chassis-ground.html)

Prune 22nd January 2004 10:28 AM

Chassis and ground
 
Consider the following setup:
DAC is housed in one chassis and power supply in another, and both are put in a bigger chassis; also, a ground loop breaker is used to separate signal ground (10 ohm resistor paralleled by a small capacitor to pass high frequencies, and two antiparallel diodes in case of large fault currents) as I've found that it solves ground loop problems.

Question: should all three containers be grounded? Should all be grounded at the same point, or should, say, the DAC inner chassis be grounded after the ground loop breaker (at signal ground)?


All times are GMT. The time now is 04:33 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2