Hi rah and rfbrw...
I tryed to simulate the rah last c ircuit with I2S generator (SIMetrix demo software) and it seems good : inverts the MSB...but with a little
delay...I try to recklock the signal after that to avoid the mistake...
but version of software did not accept that numerous components...
I didn't check the clock polarity edge for the simultaneous LR mode have to be inverted clock and data in offset binary form ? (take the look at the previous pictues I posted...)
*
Anyway I have PSpice 9.1 and I will try to make inprovements...
but I have the problem to establish the digi-stim signals for the I2S
does it have to be amplify or what...
*
I will post the I2S generator for SIMetrix...
*
thanks & bye...
I tryed to simulate the rah last c ircuit with I2S generator (SIMetrix demo software) and it seems good : inverts the MSB...but with a little
delay...I try to recklock the signal after that to avoid the mistake...
but version of software did not accept that numerous components...
I didn't check the clock polarity edge for the simultaneous LR mode have to be inverted clock and data in offset binary form ? (take the look at the previous pictues I posted...)
*
Anyway I have PSpice 9.1 and I will try to make inprovements...
but I have the problem to establish the digi-stim signals for the I2S
does it have to be amplify or what...
*
I will post the I2S generator for SIMetrix...
*
thanks & bye...
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.