Problem with Krell KAV 250 CD MkII

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hello,

I am looking for a shematic for the player above, requests for Krell run naturally into vacancy.
The following problem:
The charge is now running again and pulls the CD also.
Laser also drives up 3x and then up and down and
tried to focus. However, the spindle motor is not rotating, the motor I measured with external power and it works. The IC 102 is probably responsible for the spindle motor.
Without switching the whole plan is pretty unproductive,
no voltage specifications, test points.
A cow stood in the mist, because they no longer found.

I hope you can help me.
Best regards
Peter
 
Administrator
Joined 2007
Paid Member
The sequence of events is,

1) Laser on
2) Focus search initiated (lens going up/down)
3) Processor waits for FOK "focus OK" signal at which point the spindle motor is kicked to approx. correct speed.
4) The disc servo takes over and locks the speed of the disc by comparing the data rate off the disc to a known reference... the master oscillator in the player.

So yes, laser defective and the flow is interrupted.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.