The calculated input noise with 5 ohms input is 0.36nV/Vhz
The gain at 1kHz is 68db but can be adjust changing R6 value.
The distortion is with a 1mV 1KHz input signal ( 2.5 V output )
Nice circuit have you listenet to the circuit?
What about adding a diamond buffer to the output?
Best regards
I have no idea, i have only ztx 1051, 1055 and 1149(pnp)...I found them thrown out in a bin at a factory i worked in the past at.They were doing lots of very high voltage power supply so they must have used these transistors as drivers in some old products along with the classical 651, 751, 851, 951...What is the best PNP complement to the ZTX1051a ?
This week I've been thinking about alternatives to my I / V converter, because since I'm going to use 8 channels and balanced connections to the amplifier, that means I'll have to use 16 of these circuits.
A very interesting alternative is to use Jan Didden IV converter with a small change. just added a current source to increase the gain, the results are promising.
Post 948 :
On Q4 you would want to add a connection between collector and base.
"Jan Didden IV converter" - where can it be seen ?
Nice circuit have you listenet to the circuit?
What about adding a diamond buffer to the output?
Best regards
I have made the schematic just this morning based on a suggestion from Joachim Gerhard. Only tested in spice
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Digital Source
- dac I/V convertion with very low distortion