diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Digital Source (http://www.diyaudio.com/forums/digital-source/)
-   -   Quick question regarding non-oversampling (http://www.diyaudio.com/forums/digital-source/205954-quick-question-regarding-non-oversampling.html)

NATDBERG 4th February 2012 01:13 PM

Quick question regarding non-oversampling
 
Hello,

I've a DAC I want to get running in higher bit rates like 96KHz but which has a max running frequency of 400KHz.

So, to get it to run in higher rates I will have to lower the oversampling multiplier or remove it completely.

Currently it uses Yamaha 3623B with NPC 5813APT into a D20400.

Audiotuning do a drop in replacement for the Yam receiver replacing it with a CS4214.

Can I then bypass the NPC completely and run data straight from the CD4214 to the D20400 without any intermediate interface? I do realise that there will then be no digital filtering but I'm not worried about that at this point, only in the experiment of running the d20400 at 20/96 or 20/192.

Any help would be much appreciated.

SoNic_real_one 4th February 2012 02:05 PM

You cannot remove it, it does more than just filtering. Usually when it is used, performs a conversion too, because the DAC after it won't accept i2s signals (resulted from the receiver chips).
You need to play with the clock divider pins "CKDV" and "CKSL" to match the input rates.
Try pulling CKDV 'low'.

NATDBERG 7th February 2012 07:34 PM

Thanks SoNic - I have the D20400 data sheet so I'll have look as to what signals it can take and how it currently is wired to the NPC on the circuit in the DAC..

SoNic_real_one 7th February 2012 08:48 PM

I was talking about the OS filter: NPC 5813APT.


All times are GMT. The time now is 06:36 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2