The laser block is Hitachi HOP1200S (replace the existing HOP1200N or R that you might have). Cost on eBay is around 15$.
The traverse mechanism will cost about 80-100$ on different places... A source for it. It is not necessary to be replaced as a whole but it is easier job.
The traverse mechanism will cost about 80-100$ on different places... A source for it. It is not necessary to be replaced as a whole but it is easier job.
Last edited:
Denon DCD 1650AE/2000AE laser pickup
Hi Guys,
My CD/SACD player does not want to read 50% of the CDs I have.
From the service manual I found the part number 9KA2A506B.
Apparently I found that DVD 5910 uses the same one.
I would greatly appreciate it if somebody could confirm I can use the same
Hitachi HOP 1200 for $10-20 instead of byuing whole assembly (called traverse mech) for $ 150.Any other sources /references are much appreciated
Thank you,
Eugene
Hi Guys,
My CD/SACD player does not want to read 50% of the CDs I have.
From the service manual I found the part number 9KA2A506B.
Apparently I found that DVD 5910 uses the same one.
I would greatly appreciate it if somebody could confirm I can use the same
Hitachi HOP 1200 for $10-20 instead of byuing whole assembly (called traverse mech) for $ 150.Any other sources /references are much appreciated
Thank you,
Eugene
I ordered the exact part( whole pickup assembly with motor & laser) the first time & it came with a newer version pickup. It still has to be adjusted slightly even though it was supposed to be adjusted already from the factory. I did order a bare pickup for a 3910 later on & it required much more adjustment. If I were to buy one I would go with the newer s series since adjustments are on top & you don't have to take the pickup out just to turn the pot. Hope this helps. Donald
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Digital Source
- Denon 5910 DVD mechanism