diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Digital Source (http://www.diyaudio.com/forums/digital-source/)
-   -   Audio Alchemy DST cable power supply (http://www.diyaudio.com/forums/digital-source/145087-audio-alchemy-dst-cable-power-supply.html)

gfishe 31st May 2009 08:39 PM

Audio Alchemy DST cable power supply
 
I posted this question on rec.audio.tech, but given the low signal-to-noise ratio there I"m sure I have a better chance for an answer here. :)

I misplaced the power supply for my Audio Alchemy data stream transceiver (DST) powered digital cable. I have the "owner's manual" that came with it, but it doesn't discuss the power requirements.

Can anyone describe for me the connector (1/8" mini phone plug?) polarity and voltage?

Thanks in advance...

lanceness 17th June 2013 04:55 PM

I only just noticed this while looking for a data sheet (manual) for the same model DST,
the power supply is 12VDC @ 150ma and though it uses an 1/8" plug it has three contacts which measured with no load +16.5v tip, -16.5v middle, ground bottom. The supply has an address of mfr Engineering Design and Sales, Danville, VA 24541. Good luck.

If you still have the unit any chance you could scan the data sheet for me?

-Lance


All times are GMT. The time now is 11:19 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2